How to Check Replacement Phone Screens Before Placing a Bulk Order
Approve a sample against the exact phone variant you intend to supply, measure its brightness under agreed conditions, and put the lot inspection rules on the purchase order. For mobile repair parts wholesalers in India, the practical decision is whether the sample your repair customers can fit and test is also a reliable reference for the stock they will receive.
1. Match the sample to the phone and assembly type
Send the supplier the phone's exact model code and the replacement part number. Ask for a compatibility list that identifies the supported variants and state whether you need a screen with or without a frame. Where both 4G and 5G versions appear in the catalogue, record the exact version your customers repair.
Ask for a dimensioned drawing and check the sample against it. Compare the outer width, height and thickness, the visible display area, the camera and sensor cut-outs, and the position and orientation of the flex connector. Record the tolerances for any dimensions that affect fit. The advertised diagonal helps identify the display size. The drawing and test fit tell you whether the assembly will seat correctly.
Have a technician connect the sample to a known-good phone before applying adhesive. Check that it sits flush, the flex reaches without strain, and the image and touch work across the display, including the edges. Label the approved sample with its part number, revision and phone model code. Keep a copy of the drawing and the test record with the order.
2. Agree on how to measure brightness
Ask the supplier for the luminance in cd/m² and have them identify the minimum acceptance value, the typical value if available, and the reading taken on your sample. Put the measurement conditions next to those numbers so your technician and the supplier can repeat the same test.
| Agree in advance | Record on the sample report |
|---|---|
| Test setup | Phone or test fixture, available power or backlight settings, and brightness mode |
| Display conditions | Full-white pattern if agreed, fixed brightness setting, warm-up time and ambient conditions |
| Measurement | Meter, measurement position and angle, plus the points used if uniformity is checked |
| Acceptance | Minimum luminance and any separate uniformity limit, with the measured results |
If you test on a phone, record whether adaptive brightness and any high-brightness mode were enabled. For a screen that looks bright in the centre and dim at the edges, agree on a multi-point measurement and a uniformity limit. A short video can document flicker or visible unevenness. Use the meter readings to decide whether the sample meets the agreed brightness requirement.
3. Put the production lot inspection in writing
Use the approved sample to set the reference for fit and appearance. For the shipping lot, agree on how units are selected across cartons, how many units will be checked, and what results will trigger a hold or rejection. If the order combines several model variants, write down how each variant will be covered.
Define the defects before inspection. For example, agree how to classify a wrong connector, no image, a dead touch area, visible lines and cosmetic marks. For appearance checks, document the lighting, viewing distance and defect limits. Photos of acceptable and unacceptable examples help the inspector apply the same criteria across the lot.
If you use ISO 2859-1, record the agreed edition, lot size, inspection level, AQL by defect class, and the resulting sample size and acceptance and rejection numbers. AQL is an input to the sampling plan. The plan determines when the lot passes or fails based on the sampled units. ISO 2859-1 overview
Ask for a report that identifies the lot, the variants tested, the number inspected and the findings by defect class. Agree in advance who can release a held lot and whether sorting, replacement or reinspection is required before shipment.
What to send with your sample approval
Send the supplier the approved part number and revision, the phone model code and assembly type, the drawing and test-fit result, the brightness limit and test setup, and the lot inspection plan. Approve the bulk order once the supplier confirms that these same requirements will apply to production and shipment.
For LCD range enquiries, share your target phone model codes and required assembly type with the supplier. Explore STMAX phone LCD screens